Installation Guide

“AQUA ULTRA” Rev.2 Ver.1 07/13

5. Locate the Support bar (05).

Adjust the Support bar to a proper position on the

Stationary glass (03) and the wall. Level it

horizontally. Hold it firmly and outline the bracket’s

position on the wall. Remove the Support bar and

detach the wall bracket from it. Place the bracket

against its outlined position on the wall and mark the

drilling hole.

Drill the hole using Ø 5/16” drill bit; insert the Wall

anchor (07) and fasten the bracket to the wall with

the Countersunk screw ST4.2×40 (08). Attach the

Support bar to the wall and the Stationary glass and

tighten the set screws and the glass holding screw to

secure the glass.

See Fig. 7 & 8 for details.

Fig. 7

Fig. 8

Ø5/16”