Installation Guide

“AQUA ULTRA” Rev.2 Ver.1 07/13
4
Shower and Tub Door Installation
1. Place the U-Channel 2 (02) onto the
Shower base or Tub. Adjust the U-Channel 2
position in the middle of the ledge.
Mark the drill holes on the ledge through the
predrilled holes in the U-Channel 2 and drill
the holes using Ø1/8” drill bit.
NOTE: If you are installing tub door and
not drilling the holes for U-Channel 2, use
rubbing alcohol to clean the tub ledge of
dirt before applying silicone.
Apply waterproof silicone along the bottom
surface and around the holes of the U-
Channel 2 and fasten it onto the ledge with
the Countersunk screws ST4.2×25 (10）.
See Fig. 1 & 2 for details.
Fig. 1
Fig. 2
1
2
3
4
Ø1/8”
5