Installation Guide

Rev 2.2
7
7. Locate the Support bar (02).
Adjust the bar to a proper position on the glass and
the wall. Level it horizontally. Hold it firmly and
outline the bracket’s position on the wall. Remove
the Support bar and detach the wall bracket from it.
Place the wall bracket against its outlined position
on the wall and mark the drilling hole.
Drill the hole using Ø 5/16” drill bit, insert the Wall
anchor (07) and fasten the wall bracket to the wall
with the Round head Screw ST4.2×30 (08). Attach
the Support bar to the wall as shown on Fig. 7.5
and tighten the set screws and the glass holding
screw to secure the glass.
See Fig. 7 for details.
Fig. 7
8. Attach the Hinges (03) to the Stationary glass (01) with the
decorative bolts facing inside the shower. Bring the Glass
door (04) onto the Shower base.
Level up the Glass door next to the Stationary glass and
fasten the Hinges on the Glass Door. Make sure the top
edges of the Glass door and the Stationary glass are aligned.
See Fig. 8 and Fig. 9 for details.
Fig. 8