Installation Guide

Rev 2.2

3. Outline the position of the Wall brackets (06) on

the wall.

Set the Stationary glass (01) aside.

Remove the Wall bracket from the Stationary glass

and by placing it back to the outlined position mark

the drilling holes on the wall.

Drill the holes in the wall using Ø 5/16” drill bit and

insert the Wall anchors (07) for the Wall brackets.

Fasten the Wall brackets to the wall using the

Round head screw ST4.2×30 (08).

See Fig. 3 for details.

Fig. 3

4. Place the Stationary glass (01) back into

the designated position, level it vertically

and assemble the Wall brackets (06).

Slide Bottom bracket (11) into the slot on

the bottom of Stationary glass.

See Fig. 4 for details.

Fig. 4