Installation Guide

Rev 2.2
8
7. Drill the hole in the wall using Ø5/16”
drill bit and insert Wall anchor (07).
Remove the bracket from Support
bar (03) and attach it to the wall with
Round head screw ST4.2×30(10).
See Fig. 9 for details.
Fig. 9
8. Place the Support bar (03) with
channel on the Stationary glass
(02) and insert the other end into
the bracket.
Tighten the set-screws provided at
both ends of the Support bar (03).
See Fig. 10 and Fig. 11 for details.
NOTE
: Make sure to use clear
rubber gasket to prevent glass
to metal connection.
Fig. 10
1
2
3
Ø5/16"
1
2
3