Installation guide

“AQUA” Rev.3 Ver.1 02/2014
8
8. Install the Towel bar (06) onto the
Glass door (05).
Attach the Anti-water strip (11) over
the vertical edge of the Glass door (05).
Attach the Bottom anti-water strip
(12) over the bottom edge of the Glass
door.
See Fig. 9 for details.
Fig. 9
9. After final adjustment is complete, drill
holes on each end through the
predrilled holes in the Wall profile (01)
into the first layer of the aluminum
profile on the Stationary glass (02)
using Ø 1/8” drill bit.
Use 2 Round head screws ST4.2×10
(09) with the raised washers to secure
the aluminum profile on the Stationary
glass inside the Wall profile. Cover the
exposed screw heads with Decorative
caps (08).
See Fig. 10 for details.
1
2
3
Inside
Outside
Door
Door
Panel
Outside
Inside
Outside
Fig. 10
Ø 1/8”
1
2
3