Installation guide

“AQUA” Rev.3 Ver.1 02/2014

5. Place the Stationary glass (02) back into the Wall

profile (01) and assemble the Bottom bracket (14).

See Fig. 5 for details.

NOTE: Make sure to use clear rubber gasket to

prevent glass to metal connection.

Fig. 6

6. Locate the Support bar (03).

Adjust the Support bar at the angle that will provide

adequate support to the glass and the wall. Level it

horizontally. Hold it firmly and outline the bracket’s

position on the wall. Remove the Support bar and

detach the wall bracket from it. Place the wall bracket

against its outlined position on the wall and mark the

drilling hole.

Drill the hole using Ø 5/16” drill bit, insert the Wall

anchor (07) and fasten the wall bracket to the wall with

the Countersunk screw ST4.2×40 (15). Attach the

Support bar to the wall as shown on Fig. 7.4 and tighten

the set screws and the glass holding screw to secure the

glass.

See Fig. 6 for details.

NOTE: Make sure to use clear rubber gasket to

prevent glass to metal connection.

Fig. 5

Fig. 6