Installation Guide

“VITREO X” Rev.3 Ver.2 03/2014 4

Shower/Tub Door Installation

Attention: This shower/tub installation is true for both equal and variable width stationary glass

panels. The position for variable width stationary glass panels should be determined in accordance

to the installation situation. “Flipping” the glass horizontally will allow the glass to be positioned

on either side of the shower or tub.

1. Apply clear silicone along the inner channel of the Glass

profile (01) and push the Stationary glass (03) inside the

channel.

Slide the Stationary glass assembly into the groove of the

Wall profile (02).

NOTE: The small holes on the Stationary glass should be

away from the wall and facing the door opening.

NOTE: If you have difficulty sliding the Glass profile over the

Stationary glass, you can slightly tap on the Glass profile with

a rubber mallet and a piece of wood. Please do not strike

directly on the profile or on the edge of the glass panel.

See Fig. 1 and Fig. 2 for details.

Fig. 1

Fig. 2