Installation Guide

“Elegance” Rev.4 Ver.1 07/2013

Style “C”: Support Bar Assembly and Installation

NOTE: Use parts from Diagram “C” for the Support Bar assembly and installation.

42. Locate the Support bar (22).

Adjust the bar to a proper position on the glass and the

wall. Level it horizontally. Hold it firmly and outline the

bracket’s position on the wall. Remove the Support bar

and detach the wall bracket from it. Place the wall bracket

against its outlined position on the wall and mark the

drilling hole.

Drill the hole using Ø 5/16” drill bit, insert the Wall

anchor (23) and fasten the wall bracket to the wall with

the Big flat head screws ST4.2×40 (24). Attach the

Support bar to the wall as shown on Fig. 45.6 and tighten

the set screws and the glass holding screw to secure the

glass.

See fig. 45 for details.

Fig. 45

Ø5/16”