Installation Guide

“Elegance” Rev.4 Ver.1 07/2013

37. Adjust the width of the opening section of the Glass

door (03) by loosen the holding screws on the Pivot

assemblies (07). Level the Glass door and the

Stationary glass (21) position to ensure the Glass

door has a tight contact to the flange of the Anti-

water strip (10) from top to bottom.

Install the Bracket (27) onto the Stationary glass and

drill the hole using Ø 1/8” drill bit.

Use Round head screws ST4.2×25 (25) to attach the

Bracket to the shower base or the threshold.

Cover the screw location with Decorative cover (26).

See fig. 40 for details.

Fig 40

38. Close the hole in the bottom Pivot retainer (08) with Flat head

socket bolt M6×12 (18) or you can attach the Pivot retainer to

the Shower base or threshold using Big Flat head screw ST4.2×40

(16).

Apply silicone sealant over the Screw (16) or Bolt (18) to prevent

leakage.

See fig. 41 for details.

Fig 41

4 1

Ø1/8”