Installation Guide
“Elegance” Rev.4 Ver.1 07/2013
26
34. Press the Anti-water strip (29) onto the vertical edge of
the Stationary glass (21).
Carefully butt the Stationary glass up against the wall
vertically according to the measurements in size table.
While securely holding the Stationary glass, close the
Glass Door (03) and align the Stationary glass to it.
If needed, adjust the position of the Stationary glass to
make sure the Anti-Water strip makes tight contact to
the Glass Door from top to bottom. Outline the position
of the Wall profile (05) on the wall from inside the
shower.
See fig. 36 for details.
Fig 36
35. Detach the Wall profile (05) from the Glass profile (04).
Place the Wall profile to the outlined position and mark
the drilling holes through the predrilled holes in the Wall
profile.
Drill the holes using Ø 5/16” drill bit in the wall.
Insert the Wall anchors (12) into the holes and apply
silicone along the Wall profile and around the holes.
Fasten the Wall profile to the wall with the Big flat
head Screw ST4.2×40 (16).
Push the Stationary glass (21) with the Glass profile
(04) back into the Wall profile.
See fig. 37 & 38 for details.
Fig 37
1
3
4
5
2
6
W1
1
2
3
5
4
6
Ø5/16”