Installation Guide

“Elegance” Rev.4 Ver.1 07/2013
18
21. Adjust the Stationary glass (21) position to
ensure that when the Glass door (03) is closed,
there is a gap (1/16”-1/8”) between the two glass
panels.
To adjust and secure the Stationary glass in place,
install the Bottom Bracket (27) to the Stationary
glass.
Mark the drilling hole for the bracket. Make sure
the mark is clear and visible and drill the hole using
Ø1/8” drill bit.
Use the Round head screws ST4.2×35 (25) to
attach the Bottom Bracket to the shower base or
the threshold. Cover the screw head with
Decorative screw cover (26).
See Fig. 21 for details.
Fig. 21
22. After final adjustments of the Assembled unit drill
the holes in the Glass profiles (2) and (4) through
predrilled holes in the Wall profiles (1) and (5) using
Ø 1/8” drill bit.
NOTE: You only need to drill through the first layer of
the Glass Profiles.
Use Round head screws ST4.2×10 (14) to secure
the Glass profiles inside of the Wall profiles. Cover
the exposed screw holes with Decorative cover (09).
See Fig. 22 for details.
Fig. 22
2
3
4
6
5
1
Ø1
/
8”
1/16”--1/8”
2
4
3
5
6
1
Ø1
/
8”
Ø1
/
8”