Installation Guide

“Elegance” Rev.4 Ver.1 07/2013
17
19. Draw a line along the inner edge of the Wall
profile (05) on the wall. Detach the Wall
profile from the Stationary glass (21) and
the Glass profile (04) assembly. Place the
Wall profile to the outlined position and
mark the drilling holes through the predrilled
holes in the Wall profile.
Now drill the holes using Ø 5/16” drill bit in
the wall.
See Fig. 19 for details.
Fig. 19
20. Insert the Wall anchors (12) into the holes
and apply silicone along the Wall profile
(05) and around the holes. Fasten the Wall
profile to the wall with the Big flat head
Screw ST4.2×40 (16).
Push the Stationary glass (21) with the
Glass profile (04) back into the Wall
profile.
See Fig. 20 for details.
Fig. 20
1
2 3
Ø5/16”
2
3 1
4