Installation Guide
“Elegance” Rev.4 Ver.1 07/2013
16
Style “B”: Stationary Glass Assembly and Installation
NOTE: Use parts from Diagram “B” and “C” for the Stationary Glass assembly and installation.
17. Apply clear silicone along the inner channel of the Glass
profile (04) and push the Stationary glass (21) inside the
channel.
NOTE: If you have difficulty sliding the Glass profile over the
Stationary glass, you can slightly tap on the Glass profile
with a rubber mallet and a piece of wood. Please do not
strike directly on the profile.
NEVER use the metal hammer or hit the profile
without the wood bumper.
Push the Stationary glass with attached Glass profile inside
the Wall profile (05).
See Fig. 17 for details.
NOTE: Please note that the hole in the corner of the Glass
panel should be at the bottom, farther from the wall.
Fig. 17
18. Press the Anti-Water strip (28) onto the
vertical edge of the Stationary glass (21).
Align the Stationary glass with the Glass
Door (03) and then close the Glass door.
If needed adjust the position of the
Stationary glass to make sure the Anti-
water strip and the Glass door work well.
See Fig. 18 for details.
Fig. 18
2
3
1
3
2
1
±0.0