Installation Guide

“Elegance” Rev.4 Ver.1 07/2013
14
14. Adjust the width of the Glass door (03) by
pulling out the Glass profiles (02) and (04) if it
necessary for size of your door.
Adjust the Glass door using a level and tighten
in place with the Round head socket bolt
M6×12 (17). Close the glass door and make
sure that there is 1/16" - 1/8" gap between the
glass door and the anti-water strip.
See Fig. 14 for details.
Fig. 14
15. After final adjustments of the Assembled unit drill
the holes in the Glass profiles (02) and (04)
through predrilled holes in the Wall profiles (01)
and (05) using Ø 1/8” drill bit.
NOTE: You only need to drill through the first layer
of the Glass Profiles.
Use Round head screws ST4.2×10 (14) to secure
the Glass profiles inside of the Wall profiles.
Cover the exposed screw holes with Decorative
cover (09).
See Fig. 15 for details.
Fig. 15
3 1
2
1/16”--1/8”
2
4
5
6
3
1
Ø1
/
8”
Ø1
/
8”
±0.0