Installation Guide
“Elegance” Rev.4 Ver.1 07/2013
13
12. Use a level to ensure that the Glass door (03)
and the Wall profile (05) is absolutely vertical.
Draw a line along the vertical edge of the Wall
profile on the wall. Detach the Wall profile
from the Glass profile (04). Place the Wall
profile to the outlined position and mark the
drilling holes through the predrilled holes in the
Wall profile.
Drill the holes using Ø 5/16” drill bit in the wall
See Fig. 12 for details.
Fig. 12
13. Insert the Wall anchors (12) into the holes and apply
silicone along the Wall profile (05) and around the
holes. Fasten the Wall profile to the wall with the Big
flat head Screw ST4.2×40 (16).
Push the Glass profile (04) assembly back into the
Wall profile.
See Fig. 13 for details.
Fig. 13
1
4
3
2
Ø5/16”
2
1
3