Instructions / Assembly

Rev 1.1.
4
Acrylic Wall Installation
1. Install the tray prior acrylic back walls installation. Follow your tray installation
instructions to install it properly.
2. Surface must be dry, smooth and free of any dust, soap scum or any other
contaminants. Run a bead of silicone or adhesive on the corner wall piece and along the
wall area where the wall corner piece will rest. It should be applied on one panel at a
time or it will start to set (Fig 1 & 2).
3. Place the panel in position and apply pressure to the complete surface top to bottom to
ensure good overall contact (Fig 3).
4. Run a bead of silicone down the next area where the side panel will rest (this should be
the side where there are no controls or valves) (Fig 4).
5. Place the side panel in position and apply pressure to the complete surface top to
bottom to ensure good overall contact. DO NOT trim (Fig 5).
6. Carefully measure and drill the holes in the second side panel which will accommodate
the shower head and mixing valves. Make sure that all plumbing fixtures protrude
through the acrylic walls when it is put in position (Fig 6 & 7).
7. Apply a wide bead of silicone down the area where the second panel will rest. Run a
bead of silicone along the panel (make sure silicone is applied around the cut out holes)
(Fig 8).
8. Place the side panel in position and apply pressure to the complete surface top to
bottom to ensure good overall contact. DO NOT trim (Fig 9).
9. Without permanently installing the front enclosure, mark the outer edges of the vertical
profiles (Fig 10 & 11).
10. Using knife trim the excess of the acrylic panels (Fig 12 & 13).
11. Apply a final layer of the caulking material to the vertical and horizontal outside seams
where the panels are joined and meet the tub (Fig 14).
Fig 1
Fig 2