Instructions / Assembly

Preparation
1. After opening all the boxes, read this introduction carefully, check all the packed parts
are complete by cross checking all the components. Examine for shipping damage. If
the unit has been damaged or has a finishing defect, please contact your local
distributor within 3 business days. Please note that Bath Authority™ / DreamLine™
will not replace any damaged product or parts free of charge after 3 business
days or if the product has been installed. Contact your distributor if you have any
questions.
2. Please note that you should consult your local building codes on questions on
installation compliance standards. Building and plumbing codes vary by
location, and DreamLine is not responsible for code compliance standards for
your project.
3. This acrylic wall system is specially designed to be installed over any solid surface. It
can be used with most shower enclosures with recommended sizes over existing walls
or in a new construction.
4. If you are installing the acrylic walls over existing tiles, remove all loose tiles before
installing. If you are installing over existing painted walls, take all loose paint off.
5. Make sure to turn off water supply, remove faucet handles or any fixture trims
protruding from the wall. Clean the surface removing soap film and dirt from all wall
surfaces using regular household detergent, then wipe dry.
Tools Required
Pencil, Tape measure, caulking gun, Spirit level with horizontal and vertical indicators, knife,
(may be required for shower enclosure installation: Electric drill, Phillips screwdriver,
Slotted screwdriver) and any additional tools needed to remove faucet fixtures.
This acrylic walls system is designed to be installed
in the shower enclosure space from 32” up to 40”.
You can use any adhesive designed for acrylic
panels or clear silicone. You may also use Liquid
Nails Adhesives LN-915 or LN-715. When you use
any adhesive, please, follow the recommendation of
the adhesive manufacturer on using their product.