Installation Guide

11VISIONS Shower and Tub Door Manual Ver 2 08/2018

Tip: Apply a thin bead of

silicone onto the bottom rail

where the panel glass sits

prior to the final installation

of the panel glass.

Fig 9

Ø1/8”

inside

panel glass

Ø1/8”

inside

(x4)

inside

9. It is necessary to drill new Ø1/8” holes into the Guide Rails (#03) to attach the Glass Holders (#16).

Slide both lites of Panel Glass (#05) all the way into the grooves of the Glass Profiles (#01) on both

sides. Hold the Glass Holders (#16) in place and mark the new holes with a pencil or a drill bit.

Remove the Panel Glass (#05) to prevent damage prior to drilling into the Guide Rails (#03).

Drill Ø1/8” holes into the Guide Rails (#03). Reinstall the Panel Glass (#05) and attach the Glass

Holders (#16) to the Guide Rails (#03) using the ST4.2×16 Countersunk Screws (#13). (Fig 9)