Installation Guide

8VISIONS Shower and Tub Door Manual Ver 2 08/2018

(Bottom Guide Rail shown)

Fig 3

Fig 4

Ø1/8"

ATTENTION: Do Not drill the Guide Rail (#03)

throughout, only through the first layer.

TIP: For ease of assembly, add some liquid soap, wax or lubricant to the screws prior to

attaching the glass profiles to the guide rails. Use a low setting on the power drill to

prevent stripping the screws.

inside

outside

(x8)

3. After the Top and Bottom Guide Rails (#03)

have been cut to size, re-install the roller stoppers

on both of the Top and Bottom Guide Rails (#03).

Note: It is important that these roller stoppers

are installed at the correct locations.

Remove the existing stopper. Mark the drilling hole

at a distance of 2” from the end of the Top and

Bottom Guide Rails (#03).

Drill a new hole using an Ø1/8” drill bit; then

re-secure the stopper with the screw. (Fig 3)

4. Secure the Bottom Guide Rail (#03) and Top Guide Rail (#03) to the Glass Profiles (#01) with

the ST4.2×25 Pan Head Screws (#11). (Fig 4)