Installation Guide

10VISIONS Shower and Tub Door Manual Ver 2 08/2018

Fig 7

Ø5/16"

Fig 8

ST4.2×55

Overhead view

NOTE: Use steady, even pressure when installing

the screws to prevent stripping the screw heads!

Extender driver bit

inside

(x8)

left wall profile installation shown

7. Use an assistant to hold the assembly in position and mark the holes for drilling on the wall

through the holes in the Glass Profiles (#01) and the Wall Profiles (#02). Set the assembled unit

aside. Drill the holes using a Ø5/16” drill bit and insert the Wall Anchors (#15). (Fig 7)

8. Apply silicone caulk to the rear surface of the Wall Profiles (#02), the underside of the Bottom

Guide Rail (#03), and around the drilled holes in the wall. Place the entire shower assembly back

into the designated position and secure it to the walls using the ST4.2×55 Pan Head Screws (#10).

The screws will pass through the larger holes in the Glass Profile (#01) and secure the Wall Profiles

(#02) to each wall. (Fig 8)