Installation Guide

VISIONS Ver 1 Rev 7 07/2015
6
4.
Fasten the bottom Guide rail (#03) to the Glass profiles
(#01) with the Round head screws ST4.2x25 (#11).
See Fig. 5 for details.
Fig. 5
5.
Slide both pieces of Stationary glass (#05) fully into the
grooves of the Glass profiles (#01), and then secure
them using the Glass holders (#16) to the bottom Guide
rail (#03) using the ST4.2 x 16 FH screws (#13). It may be
necessary to drill an Ø 1/8” hole in the rails to attach the
Glass holders (#16). Mark the holes and remove the glass to
drill these holes to prevent damaging or breaking the glass
while drilling.
See Fig. 6 for details.
Fig. 6
2
1
3
TIP: For ease of assembly, add some liquid soap or wax to
lubricate the screws prior to attaching the glass profiles to
the guide rails. Also, use a low setting on your power drill
to prevent stripping the screws during assembly.