Installation Guide

VISIONS Ver 1 Rev 7 07/2015
4
Shower Door Installation
1.
Measure the distance between the two
finished walls at the top, middle and
bottom. This distance is marked as
“W”.
Also check the threshold for level and
the walls for plumb.
See Fig. 1 for details.
Fig. 1
2.
Your Guide rails (#03) have
been precut for the model width
of: 60”. (the rails are shorter than
the model width by design).
If W is less than 60" (W<60”), then
you will need to cut the Guide rails
(#03) equally from both ends.
Model Width-Finished opening W = L
The length to cut off will be "L".
See Fig. 2 & Fig. 3 for details.
Fig. 2
L
L
L
W
In order to keep the pre-drilled center
stopper holes centered, it is necessary
to cut the top and bottom guide rails
equally from both ends. Take L and
divide by 2 and cut off equally from
each end.
Example:
60"(m
odel) -58" opening = 2"
2" divide by 2 = 1" (cut from each end)