Installation Guide

INFINITY-Z shower and tub door manual Ver 5 08/2017

inside

NOTE: Do not overtighten the wheels.

Fig 14

1 42 3

Fig 13

12. From inside the shower, insert the bottom Wheel Assemblies (#17) into the Bottom Guide Rail

(#03), lift the door up and set the top Wheel Assemblies (#17) into the Top Guide Rail (#03).

Test the operation of the door, and if necessary, use a #2 Phillips screwdriver (do not use a power

screwdriver) to adjust the upper wheels so the door rolls smoothly and the closes tight. (Fig 14)

11. Fasten the top and the bottom Wheel Assemblies (#17) to the Door Glass (#04). All wheels

should be installed to face the outside of the shower. The door can be adjusted using the adjustable

bolt on the top wheels (Fig. #13.4). The push-button on the bottom wheel should point up, and can be

pressed to release the spring-loaded bottom wheel to assist in installation into the Bottom Guide Rail

(#03). Be sure the handle holes are on the correct side for the installation. (Fig 13)

NOTE: The lock nut of the upper wheel (Fig 13.4) and the push-button on the bottom wheel (Fig 13.1)

should be pointing up for easy access.