Installation Guide

INFINITY-Z shower and tub door manual Ver 5 08/2017

Fig 9

Ø5/16"

Note: The screwheads on the ST4.2 x 55 Pan Head

Screws (#09) will pass through the larger holes in

the Glass Profiles (#01) and then secure the Wall

Profiles (#02) to each wall.

Fig 10

ST4.2X55

Overhead view

Extender driver bit

recommended

inside

8. Apply silicone caulk to the rear surface of the Wall Profiles (#02) and around the holes on the wall.

Also apply silicone caulk under the Bottom Guide Rail (#03). Place the entire shower assembly back

into the designated position and secure it to the walls using the Pan Head Screws ST4.2×55 (#09).

The screws will pass through the larger holes in the Glass Profile (#01) and secure the Wall Profiles

(#02) to each wall. (Fig 10)

7. Use an assistant to hold the assembly in position and mark the holes for drilling on the wall through

the holes in the Glass Profiles (#01) and the Wall Profiles (#02). Gently set the assembled unit aside;

drill the holes using a Ø5/16” drill bit and insert the Wall Anchors (#14). (Fig 9)