Installation Guide

©2017 DreamLine. All Rights Reserved
INFINITY-Z shower and tub door manual Ver 5 08/2017
8
Fig 7
*NOTE: At this step you can reverse the handing
of the installation by flipping the assembly top to
bottom so that the panel glass installs on the
opposite side.
Fig 6
1
2 3
Inside
of
shower
!
6. Move the assembled frame into the designated
position on the shower base*, bathtub or
threshold (depending on your installation), and
push the Wall Profiles (#02) tight to the walls to
compensate for any out-of-plumb conditions.
Push the bottom rail down tight to the threshold
and adjust the frame to a vertical position. Confirm
with a level before marking the holes for drilling.
(Fig 7)
5. Slide the Wall Profiles (#02) all the way onto the Glass Profiles (#01) on both sides. Note that the
holes in the wall profiles are off-center, and should line up with the back side of the frame, in-line with
the groove for the panel glass (Fig 6.1). (Fig 6)