Installation Guide

Ver. 1, Rev. 1
6
5. Mark the measurement “W” on the Back Panel (09)
and draw straight lines from top to bottom.
NOTE:
The Back Panel has to be trimmed equally from both
sides.
See Fig. 5 for details.
Fig. 5
6. Place the Back Panel (09) on a flat piece of plywood
or particle board. Use a sharp industrial knife and a
T-square to score along the marked side ends of the
Back panel and continue scoring until you have fully
cut through the panel.
See Fig. 6 and Fig. 7 for details.
Fig. 6
1
2
W
to cut
Line
to cut
Line