Installation Guide

“SLIMLINE SHOWER BASE” Ver.5 Rev.5 06/2015
2
Preparation
1. Prior to installation, examine all boxes and packages for shipping damage and compare the
piece count with your packing slip. After opening all boxes and packages, read this introduction
carefully. Check that all of the needed parts are included in the package by checking off the
components on the “Detailed Diagram of Shower Door Components”. If the unit has been
damaged, has a finishing defect, or has missing parts, please contact our customer support
department within 5 business days of the delivery date. Please note that DreamLine
TM
will not
replace any damaged products or missing parts free of charge after 10 business days or if
the product has been installed. Feel free to contact DreamLine
TM
if you have any questions,
and please provide an order number, job name or other proof of purchase to help us identify
your original order.
2. Install all of the required plumbing and drainage before installing the shower base. Use a
competent and licensed (if required by local code) plumber for all plumbing installation.
3. Shower bases must be installed by a licensed plumber. Please note that you should
consult your local building codes with questions on installation compliance standards.
Building and plumbing codes may vary by location, and DreamLine is not responsible for
code compliance standards for your project.
4. Please insure that prior to the installation the installation surface is leveled and solid and will be
able to support the total weight of the unit. Also make sure the walls are at right angles. While
some adjustment in leveling of the tray is possible, irregular installation surface level or
improper angle of side walls will result in serious problems for your installation. Please, note
that some adjustments may be necessary during the installation process.
IMPORTANT NOTE: Dimensions provided are for reference only. You must
measure the actual shower tray sizes before installation, this includes overall
dimensions and drain location. Allowed tolerance for center of the drain is
±1/2".
Tools Required
XXX
Tape
Measure
Pencil
Level
Mortar