Installation Guide

Q-Wall 5.2 (w/two back panels) manual Ver. 1 Rev. 2 08/2015
9
9. Determine the position of both
Side panels (01).
NOTE:
a) The narrow edge of the Side
panel fits behind the corner
cover and cannot be trimmed.
b) The wide edge of the Side
panel can be trimmed to the
size of your measurements
from Step. 8.
Measure from the narrow edge of
the Side panel and place a mark
at a distance of "D" (that you
measured in Step. 8).
Draw a straight line from top to
bottom along the wide edge of
the Side panel.
See Fig. 11 for details.
Fig. 11
10. Place the Side panel (01) on a flat piece of plywood
or particle board. Use a sharp industrial knife and a T-
square to score along the marked wide ends of the
Side panel and continue scoring until you have fully
cut through the panel.
See Fig. 12 and Fig. 13 for details.
Fig. 12
1
2
D
D
to cut
Line
to cut
Line