Installation Guide

Ver. 1, Rev. 1
5
3. The Back Panel (09) has 3-1/8” flange on both sides and
has to be cut equally from both sides if necessary.
See Fig. 3 for details.
Fig. 3
4. Measure the Back Panel (09).
The Width of the Back Panel has to be less than or equal to
the distance between the two lines on the back wall in Step. 2
L ≤ W
If the width of the Back Panel is greater than the distance
between the two vertical lines on the back wall from Step. 2
,
you will have to trim the Back Panel to fit your measurement.
See Fig. 4 for details.
Fig. 4
3
1
/
8
"
3
1
/
8
"
L