Installation Guide

Q-Wall 5.2 (w/two back panels) manual Ver. 1 Rev. 2 08/2015
17
21. Slide the narrow edge of the Side
panel (01) behind the Corner
cover (02).
Align trimmed edge of the Side
panel (from Step. 9) with the
marked line on the wall (in Step. 7)
and push the Side panel against
the wall.
NOTE:
Make sure the drilled holes on the
Side panel are also aligned with
the fixtures on the wall.
See Fig. 27 for details.
Fig. 27
22. Apply sealant to the entire surface of
the reverse side of the other Side
panel (01).
See Fig. 26 for details.
Slide the narrow edge of the other
Side panel (01) behind the Corner
cover (02).
Align trimmed edge of the Side panel
(from Step. 9) with the marked line on
the wall (in Step. 7) and push the Side
panel against the wall.
Align the top of both Side panels and
the Back panel before the sealant sets.
Apply equal pressure to the whole
surface of the Acrylic panels from top
to bottom.
See Fig. 28 for details.
Fig. 28
1
2
1
2