Installation Guide

SLIMLINE SHOWER BASE manual Ver 5 Rev 9 03/2018

Preparation

1. Prior to installation, examine all boxes and packages for shipping damage and compare the

piece count with your packing slip. After opening all boxes and packages read this introduction

carefully. Check that all of the needed parts are included in the package by checking off the

components on the “Detailed Diagram of Shower Door Components”. If the unit has been

damaged, has a finishing defect, or has missing parts, please contact our customer support

department within 3 business days of the delivery date. Please note that DreamLine

will not

replace any damaged products or missing parts free of charge after 3 business days or if

the product has been installed. Please contact DreamLine

if you have any questions and

please provide an order number, job name or other proof of purchase to help identify the

original order.

2. Install all of the required plumbing and drainage before installing the shower base. Use a

competent and licensed (if required by local code) plumber for all plumbing installation.

3. Shower bases must be installed by a licensed plumber. Please note that you should

consult your local building codes with questions on installation compliance standards.

Building and plumbing codes may vary by location and DreamLine

is not responsible for

code compliance standards for your project.

4. Make sure that prior to the installation the installation surface is leveled and solid and will be

able to support the total weight of the unit. Also make sure the walls are at right angles. While

some adjustment in leveling of the tray is possible, irregular installation surface level or

improper angle of side walls will result in serious problems for your installation. Please note

that some adjustments may be necessary during the installation process.

5. Center drain configurations are centered on the width only. See technical drawing tables

for drain locations.

6. Drain not included with this product. The drain

opening

is 3-3/8” in diameter and accepts a

standard 2” compression fitted drain.

IMPORTANT NOTE:

Dimensions provided are for reference only. Measure the actual shower tray

before installation. This includes overall dimensions and drain location.

Allowed tolerance for center of the drain is +/-1/2".

Tools Required

XXX

Tape

Measure

Pencil

Level

Mortar