Installation Guide

Installation steps
5Q-Wall 2 manual Ver 3 Rev 2 11/2015
Fig 1
Fig 2
Fig 3
71-1/2”
(1816mm)
11”
(280mm)
T
i
l
e
W
a
l
l
b
o
a
r
d
1. The shower base must be installed prior to
installation of the acrylic back wall kit.
Follow the manual instructions for proper
installation of the shower base.
2. Surface must be dry, smooth and free of any dust,
debris or any other contaminants. Run several beads of
adhesive on the Corner Acrylic Panel and along the wall
area where the Corner Acrylic Panel will attach,
extending at least 11” out from the corner to a height of
71-1/2”.
See Fig 2 and Fig 3 for details.
Note: Acrylic wall panels can be installed onto
tile (Fig 1) or wallboard (Fig 2) Use the correct type
of adhesive designed for your particular wall
material that is also safe for use with acrylic.
Note: Adhesive should only be applied to one panel
at a time, otherwise it may start to set before you
are ready to attach the panels. Consult the adhesive
manufacturer’s guidelines for specific information.
apply adhesive to
the back surface of
the acrylic corner
panel