Installation Guide

ManualsBrandsDreamLine ManualsBathroomUnidoor Madrid 72-in H x 58-in to 58.5-in W Frameless Hinged Satin Black Shower Door (Clear Glass)

Tools Needed

*if necessary

Parts Needed

UNIDOOR MADRID Shower Door and Inline Panel Manual Ver 1 122019 13

To prevent stripping

the screw heads, use

low torque and

steady pressure

when installing the

screws. Make sure to

drill Ø1/8” (3mm)

pilot holes into the

studs.

Fig 3

*If Minor Out-of-Plumb Conditions

were discovered in Step 1a:

Use the appropriate PVC Hinge Spacer(s)

(#31) behind the Hinge Assembly (#05)

before securing them to the wall with the

ST5.5×70mm Countersunk Screws (#04)

(see pg 11)

1mm

2mm

3mm

NOTE

TIP

The PVC Hinge Spacers (#31) can be

used as a template to assist with marking

the hinge mounting holes accurately

Use a diamond-tipped bit and low

torque when drilling into porcelain

or other hard tile surface. Follow

the drill bit manufacturer’s

guidelines for proper use.

NOTE

For installation into a stud or other wood

reinforcement behind the finished wall (Required):

◾drill a Ø1/4”(6mm) hole up to the stud, drill an

Ø1/8”(3mm) pilot hole into the stud and use

the ST5.5 x 70mm Countersunk Screws (#04).

*see below

Door Glass Installation OPTION A: (Install Door Glass with the

hinges attached) Use caution while installing the hinge to the wall to

avoid scratching the finished surface of the Hinge Assembly (#05)

face plates. The manufacturer recommends using an extension driver

bit to install these long screws. Painter’s Tape can also be used on the

face plates to protect the hinge finish.

TIP