Installation Guide

UNIDOOR-X (STYLE M) manual Ver 2 Rev 1 02/2019

Leave the spacers or shims in

place beneath the door glass for

at least 24 hours after installation.

5/8"

5/8” spacer

IMPORTANT STEPS TO FOLLOW:

◻ Use 100% silicone caulk - a quick-drying or fast-curing silicone is

recommended for the installation of hinge panel glass into the u-channels

◻ Apply enough silicone into the u-channels to secure the panel glass

◻ Fully tighten the hinge panel glass bracket or L-Bar™ during the

installation of hinge panel glass

◻ DO NOT remove the spacers or shims from beneath the door

glass for 24 hours to allow the silicone to fully cure to hold the

hinge panel glass securely in the u-channels

◻ The hinge panel glass for this model should not be adjusted

more than 1/4” within the u-channel for an out-of-plumb wall

condition

◻ Refer to the product installation manual for more details

UNIDOOR-X Tub door shown as an example

Hours

The hinge panel glass must be properly installed and secured to support the

weight of the door glass. Failure to follow these steps may result in the hinge

panel glass pulling out of the U-Channel.

100% Silicone

Hinge

Panel

Hinge

Panel

Unidoor-X shower

NOTE: Leave spacers or shims in place beneath the door glass for 24 hours.

If time allows, delay installing the door glass onto the hinge panel glass for

24 hours until the silicone securing the hinge panel glass has fully cured.

5/8"

5/8” spacer

5/8"

5/8” spacer