Installation Guide

ManualsBrandsDreamLine ManualsShower DoorsD1232272-09

Installation steps

UNIDOOR-X (STYLE M) manual Ver 2 Rev 1 02/2019

Fig A

#36

inside

outside

rubber

gasket

Fig B

6” Hinge Panel with

Hinge Panel Glass Bracket (#36)

rubber

gasket

top

NOTE: The following shower door installation instructions

should be used as a general guide and prerequisite to the

installation of the UNIDOOR Style M, M1, M2, M3, M4 and

L1 models. Before you begin the installation, please check

your finished opening size and model dimensions to ensure

proper placement of the Hinge Panel Glass (#32) and Door

Glass (#01). Specific size information can be found on our

website: DreamLine.com.

NOTE: The 24” Hinge Panel Glass (#32) installs with either a left

or right L-Bar™ (#35). (Fig A)

The 6“ Hinge Panel Glass installs with the Hinge Panel Glass

Bracket (#36). (Fig B)

This manual includes instructions for both methods.

Style M - 6” & 24” Inline Panel and Shower Door Installation

NOTE: For the 6” Hinge Panel Glass (#32) installation, begin

with Step #1. The Hinge Panel Glass Bracket (#36) installs at

the top of the vertical U-channel. (Fig B)

The Hinge Panel Glass Bracket (#36) is only for use with

the 6“ Hinge Panel Glass (#32).

DO NOT USE this bracket with the 24” hinge panel glass.

24” Hinge Panel

with left-hand L-Bar™ (#35)

NOTE: The Hinge Panel Glass Bracket (#36) is only to be installed

with the 6” Hinge Panel Glass (#32) for the UNIDOOR-X models.

Maximum out-of-plumb adjustment for Hinge Panel Glass = 1/4”

NOTE: There is a top and a bottom to the Hinge

Panel Glass (#32): The top hinge cutout is 7-7/8” to center,

the bottom hinge cutout is 8-3/8” to center. The hinge

panel glass must be installed correctly.

For the 24” Hinge Panel Glass (#32) installation with

the L-Bar™ (#35),

begin with Step #10 on Page 15.

Note: The L-Bar™ (#35) is not included with the 6”

hinge panel installation.