Installation Guide

15UNIDOOR-X Style M Ver 1 Rev 6 06/2016

Fig 10

Fig 11

3 4

Use the 5/8” spacers included

with the door glass

5/8"

5/8” spacer

door

hinge panel

5/8”

9. Attach the Hinges (05) to the Hinge Panel glass

(32) with the decorative bolts facing inside the shower.

The Door Glass (01) ships with four 5/8” shims

attached to the top (2pcs) and bottom (2pcs). Determine

the swing of the door. Remove the shims from the top

of the door glass and leave the bottom shims in place.

Set the Door Glass (01) onto the threshold at the

desired location and check for level. These 5/8” shims

will leave the proper spacing at the bottom of the door

glass and will ensure that the door height finishes at 72”,

but always confirm with a measurement.

Level up the Door Glass (01) with the Hinge Panel

glass (32) and fasten the hinges onto the Door Glass

(01) using one gasket per side. Make sure the top edges

of the Door Glass (01) and Hinge Panel glass (32) are

aligned.

Remove the 5/8” spacers from beneath the Glass door.**

See Fig. 10 for details.

10. Mount the Handle (02) to the Glass door (#01).

See Fig. 11 for details.

** NOTE: It is strongle recommended

to leave the 5/8” shims beneath the

door glass until the silicone securing

the hinge panel glass has fully cured.