Installation Guide

Troubleshooting

Prior to contacting DreamLine® Customer Service, please

have the following information readily available:

- Purchase Order Information

- Name, PO Number, Dealer/Vendor Name, etc.

- SKU/Model Number (see Page 31)

- Factory Part Information (see Page 31)

TIP

Problem/Symptom Suggested Solution Page(s)

Missing Parts

•Check all shipping/packaging material for missing parts/components.

•If not found, contact DreamLine Customer Support [1-866-731-2244] to order

factory part replacement.

――

Door Glass does not close

flush with the 180º Strike

Vinyl (#19) and Inline Panel

Glass (#11)

•Inspect the 180º Degree Strike Vinyl (#19) and ensure the orientation of the

vinyl is correct.

•Check that the 180º Degree Strike Vinyl (#19) is installed correctly so the Door

Glass closes flush with the vinyl.

•Check that the reveal between the door and the strike vinyl is consistent/even. Use

a level and adjust the assembly. Removal and re-installation may be necessary.

13;21

Top of Inline Panel Glass

(#11) is not flush with the top

of the Door Glass

• Measure that the height of the Door and Inline Panel Glass is at 72 inches.

• Refer to the Door Manual for proper installation of the door.

――

Leakage: beneath the

Bottom U-Channel (#29)

and Inline Panel (#11)

•Confirm that all screws are tightly secured to the threshold

•Inspect the silicone and ensure that a complete application of silicone

has been applied. Allow 24 hours for the silicone to cure before using the shower.

――

L-Bar™ Support Bracket

(#30) not installed level with

the Inline Panel Glass

•Review the L-Bar™ Support Bracket (#30) installation steps to adjust the L-Bar.

•Confirm the gaskets are in place to protect the glass

•Removal and re-installation may be necessary

•The L-Bar must be installed correctly for the safety of the installation

23-26

INLINE PANEL (STYLE F) Inline Panel Glass Manual Ver 2 072019 30