Installation Guide

UNIDOOR-X (STYLE M) manual Ver 2 11/2016

inside

wall

inside

wall

inside

wall

inside

wall

0 1/8”

1 2

3 4

(or Ø5/16"

& anchor

for tile)

Fig 15

Install the bottom U-channel

parallel to the outside edge

of the threshold

NOTE: If installing this hinge panel and door for

one of the Unidoor-X enclosure configurations,

it is important that the hinge panel is installed at

the correct dimension for the enclosure model

size. Refer to panel installation manual packaged

with the panel glass for details and dimensions.

12. Position the U-channel 2 (bottom profile) (#29)

onto the threshold, parallel to the outside edge. Mark

the position of the U-channel and mark the position of

the holes for drilling. You need to use at least 3 holes

for the U-channel 2 (bottom profile) (#29): one near

each end and one near the center.

• Drill the holes into the threshold using an Ø1/8” drill

bit. (Or use a Ø5/16” bit and anchor for tile)

• Apply a bead of silicone to the bottom of the

U-channel 2 (bottom profile) (#29) and attach it to

the threshold using the ST4.2 x 40mm screws (#23)

(Fig. 15)