Installation Guide

Installation steps
9
UNIDOOR-X (STYLE M) manual Ver 2 11/2016
Fig 1
#36
inside
outside
rubber
gasket
Fig 2
6” Hinge Panel with
Hinge Panel Glass Bracket (#36)
rubber
gasket
top
NOTE: The following shower door installation instructions
should be used as a general guide and prerequisite to the
installation of the UNIDOOR Style M, M1, M2, M3, M4 and
L1 models. Before you begin the installation, please check
your finished opening size and model dimensions to ensure
proper placement of the Hinge Panel Glass (#32) and Door
Glass (#01). Specific size information can be found on our
website: DreamLine.com.
NOTE: The 24” Hinge Panel Glass (#32) installs with either a left
or right L-Bracket (#35). (Fig 1)
The 6“ Hinge Panel Glass installs with the Hinge Panel Glass
Bracket (#36). (Fig 2)
This manual includes the instructions for both methods.
NOTE: There is a top and a bottom to the Hinge Panel Glass
(#32): The top hinge cutout is 7-7/8” to center, the bottom
hinge cutout is 8-3/8” to center. The hinge panel glass must
be installed correctly.
Style M - 6” & 24” Inline Panel and Shower Door Installation
NOTE: For the 6” Hinge Panel Glass (#32) installation, begin
with Step #1. The Hinge Panel Glass Bracket (#36) installs at
the top of the vertical U-channel. (Fig 2)
The Hinge Panel Glass Bracket (#36) is only for use with
the 6“ Hinge Panel Glass (#32). DO NOT USE this bracket
with the 24” hinge panel glass.
For the 24” Hinge Panel Glass (#32) installation with the
L-Bracket (#35),
begin with Step #10 on Page 15.
Note: The L-Bracket (#35) is not included with the 6” hinge
panel installation.
NOTE: It is strongly recommended that the silicone be
allowed to fully cure in the U-channels before hanging
the door glass.
24” Hinge Panel
with left L-bracket (#35)
NOTE: The Hinge Panel Glass Bracket (#36) is only to be installed
with the 6” Hinge Panel Glass (#32) for the UNIDOOR-X models.
Maximum out-of-plumb adjustment for Hinge Panel Glass = 1/4”
!
©2017 DreamLine. All Rights Reserved