Installation Guide

25UNIDOOR-X (STYLE M) manual Ver 2 11/2016

Fig 30

Fig 29

Inside shower

For Style M only: If your model does not include additional

panel glass, proceed to the next step to install the L-shaped

Strip (#08) to the wall.

24. With the door closed, place the L-shaped Strip (#08) on the

door edge and mark its location on the wall.

Please note that the corner of the L-shaped Strip (#08) should face

into the shower. (Fig 29.1 and 29.2)

With the door open, remove the tape backing from the adhesive strip

and firmly press the L-shaped Strip (#08) to the wall. Allow time for

the adhesive to set before allowing the door to close against the

L-shaped Strip (#08). (Fig 29)

NOTE:

The above procedure for installing the L-shaped Strip (#08) is for the

Unidoor Style M shower door only. If installing another model, please

refer to the separate panel glass installation manual located in the

glass packaging for model specific instructions. Hinges set to

overclose require the use of the L-shaped Strip (#08) or other strike

vinyl that ships with the panel glass.

ATTENTION:

Prior to the next step, please be sure the section of the wall

where you need to attach the L-shaped Strip (#08) is clean,

dry, and free from soap, oil or any construction debris.