Installation Guide

23
UNIDOOR-X (STYLE M) manual Ver 2 11/2016
Use the 5/8” spacers included
with the door glass
5/8"
5/8” spacer
Fig 26
Fig 25
Door
Glass
3
door
glass
2
door
glass
2mm hinge
gasket
inside
outside
1
5/8”
21. Mount the Handle (#02) to the Glass door (#01).
(Fig 26)
** NOTE: It is strongly recommended
that the 5/8” shims be left beneath the
door glass until the silicone securing
the hinge panel glass has fully cured.
20.
The Door Glass (#01) ships with four
5/8” spacers attached to the top (2pcs) and
bottom (2pcs). These 5/8” spacers will
create the proper spacing at the bottom of
the door glass and will ensure the installed
door height finishes at 72”, but always
confirm with a measurement.
Set the Door Glass (#01) with the 5/8“
spacers attached onto the threshold, inline
with the Hinge Panel Glass (#32).
Level up the Door Glass (#01) with the
Hinge Panel Glass (#32) and fasten the
hinges onto the Door Glass (#01) using
one 2mm hinge gasket per side.
Make sure the top edges of the Door Glass
(#01) and Hinge Panel Glass (#32) are
aligned and that there is an even reveal
between the door and panel glass.
Remove the 5/8” spacers from beneath the
Door Glass (#01) once the hinge panel
glass is fully secured.** (Figs 24 and 25)