CAUTION TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTES Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/or humid or moist areas. Do not attempt to clean this unit with chemical solvents as this might damage the finish. Use a clean dry cloth. Operate controls and switches as described in the manual.
POWER SOURCE This system is designed to operate on 110V AC 60Hz house current only. Connecting this system to any other power source may cause damage to the system and such damage is not covered by your warranty. NOTE: The system has an AC plug and will only fit into matching AC outlets. This is a safety feature to reduce the possibility of electric shock. If the plug will not fit in your AC outlets, you should have the outlet changed by a qualified, licensed electrician.
LOCATION OF CONTROLS AND INDICATORS TOP PANEL FRONT PANEL 5
BACK PANEL BOTTOM Display 6
1.) 2.) 3.) 4.) 5.) 6.) 7.) 8.) 9.) 10.) 11.) 12.) 13.) 14.) 15.) 16.) 17.) 18.) 19.) 20.) 21.
Remote Control 1.) PLAY / PAUSE Button 2.) IPOD UP Button 3.) SKIP / TUNE – Button 4.) ENTER Button 5.) SKIP / TUNE + Button 6.) MENU Button 7.) IPOD DOWN Button 8.) iPod/AUX Button 9.) TREBLE– Button 10.) TREBLE+ Button 11.) BASS– Button 12.) BASS+ Button 13.) MUTE Button 14.) VOLUME + Button 15.
REMOTE CONTROL BATTERY REMOTE CONTROL BATTERY The remote control requires one “button-type” 3-volt lithium battery, included. To extend the life of the original battery we have inserted a small clear plastic spacer tab between the lithium battery and the battery terminal. You must remove this battery spacer tab before you can use the remote control. To remove the tab, pull it in the direction of the arrow in the illustration as shown.
OPERATING INSTRUCTIONS Make sure the AC power cord from this unit is properly connected to a 110V 60Hz household AC power outlet. Make sure that the minimum distance around the whole unit for sufficient ventilation is 10cm. SETTING THE CLOCK When the system is connected to the AC outlet for the first time and “12:00” will keep flashing on the display. This is your indication that the time display is not set. 1.) Press the TIME button and the display will start flashing. 2.
5.) Release the SLEEP button to confirm setting. 6.) When the SLEEP time is reached the unit will turn off itself under OFF, or AUTO mode. 7.) You can shut the unit off manually during the Sleep time by pressing the SNOOZE button at any time or press the SLEEP button until -:-- appear on the display. ALARM FUNCTION 1.) Alarm Function will only activate on AUTO mode. 2.) To set the Alarm time. Press the ALARM button and the display will start flashing.
turn off itself. 11.)If SNOOZE button is pressed during the alarm is activated, the alarm is set to re-activate in 9 minutes. Warning: Do not plug in Aux while alarm is set, otherwise alarm will not be activated. Display Brightness Control This Unit features a unique display brightness control system that gives you two convenient options: When the dimmer switch is set to the position, the clock display is at full brightness. The dimmer switch was pre-set to the position at our factory.
1) Alarm Function will only activate on ON mode 2) Slide the FUNCTION switch to ON position. 3) Plug the iPod to the iPod docking station. If the iPod is in PAUSE mode before plugged in, the iPod will playback itself once plugged into the docking station. If the iPod is in PLAY mode before plugged in, the iPod will changed into PAUSE mode once plugged into the docking station. Then press PLAY/PAUSE button to start music playback.
AUXILIARY IN Connect the Audio Output jacks of your auxiliary sound source (TV, VCR, DVD Player, Cassette Deck, Mini Disc player, etc., etc.,) to the AUX IN jack on the back panel of the unit. The auxiliary function will only activate when the aux in jack is fitted with connection cable Note: The connection cables are not included. 1.) Slide the FUNCTION switch to ON position.
Back Up Function If the AC supply is interrupted, the clock display will go off and the clock setting will be canceled. To back up the clock, insert one 9V battery ( not supplied ) in the battery compartment in the base of the unit. The back up battery is not iPod operation. Note : Always use alkaline type battery and always remove the battery if the unit is not to be used for an extended period of time.
