User manual

13.0 CINEMASCOPE SETUPS
36 R699820 - Yunzi Series User Manual
13.0CINEMASCOPE SETUPS
13.1 Lens Zoom or Theater System Kit
The Yunzi Series centralizes the controls and automation commands for a unique, versatile and unexpectedly
simple to operate 2.35:1 theatre experience using Lens Zoom or Anamorphic Lens.
• Up to 10 lens position memories
• Integrated Constant Image Width (CIW) scaler with anamorphic mode A and mode B.
• Dedicated commands to control the Theater System Kit and picture size on a 2.35:1 screen.
13.2 Cinemascope setup with Lens Zoom
Select “Menu ⇒⇒
⇒⇒
Installation ⇒⇒
⇒⇒
Lens Memory 1”
Zoom in, until the left and right borders of the picture fits the 2.35:1 screen borders. Save the lens position in the
lens memory 1. You can also edit the memory 1 name to “Cinemascope”.
Select “Menu ⇒⇒
⇒⇒
Installation ⇒⇒
⇒⇒
Lens memory 2”
Make sure to project a 16:9 picture, zoom out until the picture top and bottom fit the top and bottom of the screen.
Adjust the focus and offset if required, then save this position into the memory 2. You can additionally edit the
memory name to “Standard”.
Switch format using the Remote Control Unit.
You can now switch between Cinemascope and standard formats easily by using the [Lens Mem]ory button on the
RCU and selecting the correct lens memory according to the source format.
13.3 Installing a 2.35:1 screen with the Theater System Kit
Plug the 12V Trigger output of the projector to the Anamorphic motorization
Connect the lens motorization to the 12V Trigger output
Configure into Function “Menu ⇒⇒
⇒⇒
Trigger ⇒⇒
⇒⇒
On (Anamo)”
The “Function ⇒⇒
⇒⇒
Tr igger” menu determines the 12V Trigger output located in the panel input at the rear of this unit.
This is a global parameter (for all inputs. Set the 12V Trigger to “On (Anamo)“ mode so that it is most of the time Off
and switches On when the picture is in Cinemascope format and Anamorphic mode A is selected. The picture is
then vertically stretched and the lens is needed.
• Set 12V Trigger to: “Function ⇒⇒
⇒⇒
Trigger ⇒⇒
⇒⇒
On (Anamo)”.
Video source is 16:9: set [Anamo]rphic to Off
When you select a 16:9 input choose the anamorphic OFF to obtain move the anamorphic lens out. Menu
“Installation ⇒⇒
⇒⇒
Anamorphic ⇒⇒
⇒⇒
Off”
12V Trigger
to anamorphic
motorization