User manual

7.0 PICTURE ADJUST SETTINGS
28 R699820 - Yunzi Series User Manual
• RNR: Random Noise Reduction. You can set it from 0 up to 16 to reduce the picture random noise.
• MNR: Mosquito Noise Reduction function is used to reduce the Mosquito noise on the picture, generally found in
compressed digital video signals such as television broadcast or encoded movies. Adjust the MNR value from 0
up to 16 to reduce the typical broadcast picture mosquito noise
• BNR: Block Noise Reduction uses a large portion of the picture to reduce the digital noise, this ensures a higher
quality filter. Adjust the BNR value to On or Off.
Color Management (TSL adjustments)
The Color Management gives the installer an unique calibration ease with the integrated Color Adjustment menu:
each primary, secondary colors and orange can be independently calibrated to obtain a precise color balance in a
snap. Adjust the Red, Green, Blue, Yellow, Cyan, Magenta and Orange Tints, their saturations and luminances and
store them into Custom1, Custom2 or Custom3 profiles.
User Name Edit
You can edit the picture modes names User1 to 5 using a maximum length of 10 characters. You can use alphabet
letters, numbers and symbols:
a) Select the user name you want to edit from User1 to User5. Press [OK] to enter the edit mode.
b) The input cursor displays the place where the new character will be insert. It will move automatically as a
character is selected. Use [UP], [DOWN], [LEFT] or [RIGHT] to select a character and press [OK] to insert it.
c) Press [BACK] to exit edit mode.
Clear: To delete a character: Move the cursor to the desired location and press [OK] to delete the specific character.
All Clear: To delete all characters. OK: To save the current name, a save confirmation will appear.
Clear Motion Drive (120Hz)
The Clear Motion function uses a 120Hz video processing to render a smooth and clear motion for movies shot at
24Hz or HD movies at 60Hz. Set the correct level between:
• Off: Frame interpolation is disable.
•Low: light frame interpolation
• High: strong interpolation
•Inverse Telecine: dedicated interpolation for 60i and 60p sources originally shot in 24p.
Lens Aperture
The lens is equipped with a variable electronic aperture. This function is used to optically adjust the light output
depending on the viewing conditions and the light ambiance. Adjust from the correct aperture from partially closed
to fully opened.
Lamp Power
Set the lamp power used by the current Picture Profile:
Low: lamp is set to 180W
High: lamp is set to 230W.
To avoid any damage to the lamp, you can’t change the lamp power within 90 seconds from the projector startup or
60 seconds after lamp power change.
7.11 Reset Picture Profile
Prompt a confirmation to reset the current Picture Profile to default settings.
User Name Edit
MENU
BACK
!
!
Name
User 1
Clear
All Clear OK
Exit
Select
Operate
Picture Adjust
SPACE
Select cursor Input cursor
Character list