User manual

4.0 GETTING STARTED
R699820 - Yunzi Series User Manual 17
4.2 Connecting the Power Cord
• Before plugging in the Power Cord, ensure that all devices have been connected
to their respective inputs to this unit.
• Connect the power cord to the power input terminal of the projector.
4.3 Operating LEDs
CAUTION AGAINST FIRE AND ELECTRIC SHOCK
Since the power consumption of this unit is high, insert the power plug directly into a wall outlet.
Do not use a power voltage different from that which is indicated. Do not cut, tear or modify the power cords. Also,
do not place a heavy object on, heat or stretch the power cords as this may cause damage to the cords.
ID
Operating LED
Description
STANDBY/ON
(green or red)
LAMP
(orange)
WARNING
(orange/red)
Blinking
1 red - - - Unit is in standby mode
2 green - - - Unit is in operate mode (during projection)
3 blinking green - - Ye s
Unit is in operate mode, but HIDE is ON.
Press again the HIDE button to obtain a
picture.
4 blinking red - - Ye s Unit is in cooldown mode. (switching off)
5/6 - orange - -
Lamp time has reached 2900 hours,
prepare to replace the lamp soon. If used
in low power mode, replace the lamp
before 4000 hours.
CAUTION:
When in Cool Down mode, do not pull out the plug from the outlet. Also, do not block the air inlets/exhaust
vents by standing the projector on its end or laying it on its side.
NB:
When the projector is running for more than 1 minute, the Standby/ON LED will automatically switch OFF.
STANDBY/ON
(green/red LED)
LAMP
(orange LED)
WARNING
(orange/red LED)