User manual

2.0 GETTING STARTED
8 R699761 - DreamScaler 4 User Manual
2.3 Remote Control Overview
The functions of these buttons are detailed in the next paragraph. An asterisk (*) indicates this feature will be
implemented in future software.
Power/Standby Buttons
The DreamScaler 4 remote has a Power and a Standby button. The Power button always turns the DreamScaler 4
on and the Standby button always put the unit into Standby mode.
Curtain Button
The DreamScaler 4 remote has a Curtain button which allows you to close a ‘curtain’ over the image. This feature is
especially useful when an image is paused on a display susceptible to burn-in.
Remote Control Battery Installation
The remote control for the DreamScaler 4 requires two AA batteries. These should be replaced as needed by
Alkaline batteries because they last longer without leaking.
To install the remote control batteries:
1) Locate the battery compartment on the back of the remote control.
2) Remove the cover from the back. To do this, press the tab attached to the cover and pull the cover with the
guide on the back of the remote control.
3) Remove the old batteries (if applicable).
4) Insert two new AA batteries in the compartment as shown on the inside of the battery compartment. Make sure
the batteries are correctly inserted, observing the proper polarity.
5) After installation, replace the cover and dispose of the old batteries (if applicable).
INPUT SELECT
STANDBY
POWER
INPUT
ADJUST
CONFIG
PICTURE
CONTROL
OUTPUT
SETUP
MENU EXIT
16:94:3
AUTO
VIDEO 1S-VIDEO 1COMP 1HDMI 2
VIDEO 2S-VIDEO 2COMP 2HDMI 3
ENTER
HDMI 4
BORDER CROP
INFO
CURTAIN
MEMORIES
RGBHV
HDMI 1 SDI
ASPECT
ZOOM PAN
ON/OFF
DISPLAY
PROFILES
VIEWING
MODES
INPUT
ASPECT
RATIO
TEST PATTERN
Standby
Info
Curtain
Output Setup
Configuration
Picture Control
Input Adjust
Menu
Border
Zoom
Input Select
(HDMI 1, HDMI 2, HDMI 3, HDMI 4,
Component 1, Component 2,
RGBHV/Component,
S-Video 1, S-Video 2,
Video 1, Video 2, AUTO)
Input frame AR
Navigation Keys
(Up, Left, Enter, Right, Down)
Exit
Crop (*)
Set Input frame AR to 2.35
Power
Input Aspect Ratio
12V Trigger Mode
Display Profiles
Set Input frame AR to 4:3
Set Input frame AR to 16:9
Test Patterns
(Left, On/Off, Right)
Select automatically the
active Input.
THEATRE MODE
THEATRE MODE
*
*