User manual

4.0 MENU OPTIONS
20 R699761 - DreamScaler 4 User Manual
12V Trigger Level
The 12V Trigger outputs can be programmed to operate at normal or negative logic. The options are:
• Normal: when the 12V trigger is active, the output level is 12Vcc, when inactive the outputs is set to 0 Vcc.
• Negative: when the 12V trigger is active, the output level is 0Vcc, when inactive the output is set to 12Vcc.
12V Trigger 1 state is determined by the state of the DreamScaler 4. When the DreamScaler 4 is switched ON, the
12V Trigger 1 is active, when switched OFF or in standby mode, the 12V Trigger 1 is inactive. 12V Trigger 2 is a
programmable output that can control the Theatre Anamorphic Lens position.
Information
This setting shows information about the system including:
Input Status
• Signal Type - Input Framerate / Colorspace
• De-interlacing Method
• Mosquito Noise Reduction / Fine Detail / Edge Enhancement
• Aspect Ratio (Frame/Active)
•Audio source / encoding
Output Status
•Format resolution
• Output Frame Rate
• Selected Output Preset
• 12V Trigger 1 Status / Trigger 2 Status
• Aspect Ratio (Display/Screen)
• Display Profile
This screen can be helpful during troubleshooting.
4.6 Output Setup
Analog/Digital (A/D)
Push the Down button to show the current output type. Push the Down button again to select the next item on the
list shown below. You can also use the Up button to cycle through the output types.
• Analog Output (BNC-style connectors)
• Digital Output (HDMI connector)
Output Format
This menu shows the current output format. You can change the DreamScaler 4 output signal by selecting a
different format and you can modify the output signal timings by pressing ”enter“ button. Make sure to select the
correct output format in regards to the framerate conversion.
Output Aspect Ratio Control
There are four controls for Output Aspect Ratio (OAR):
• Display Aspect Ratio
• Screen Aspect Ratio
• Image Shift
• Underscan
Aspect Ratios (Display / Screen