User`s guide

VigorTalk ATA24 Series User’s Guide

Codec Rate - Type the rate value to be applied on this port.

Codec VAD- Enable or Disable VAD (Voice Activity

Detection). It can detect whether the voice activity is

progressing or not. If not, RTP packets transmission will be

stopped for saving more bandwidth.

CAS Microphone Gain- The gain value while transmitting voice.

The default value is 0. The range is from -32 to 31.

Speaker Gain - The gain value while receiving voice. The

default value is 0. The range is from -32 to 31.

FAX FAX Mode -The FAX function mode. There are three options:

Transparent: FAX will be transmitted via voice channel; no fax

relay and no Codec change will be involved.

T.38 Relay: Using T.38 Fax Relay. This is the default value.

DTMF DTMF Mode -

InBand: Choose this one then the Vigor will send the DTMF

tone as audio directly when you press the keypad on the phone.

OutBand (RFC2833): Choose this one then the Vigor will

capture the keypad number you pressed and transform it to

digital form then send to the other side; the receiver will

generate the tone according to the digital form it receive. This

function is very useful when the network traffic congestion

occurs and it still can remain the accuracy of DTMF tone.

SIP INFO: Choose this one then the Vigor will capture the

DTMF tone and transfer it into SIP form. Then it will be sent to

the remote end with SIP message.

DTMF Volume – Determine the volume of DTMF voice signal.

The more the number is set, the greater the sound is.

Call Waiting Enable – Activate the call waiting function.

Disable – Close the call waiting function.

Port Unlocked This button is available only when current port is locked. Click

it to unlock the port.

Apply When you finish all the configurations, please click this button

to activate them.

This page allows you to set a simple way to dial a specific number. Up to 150 numbers can be

stored in VigorTalk ATA-24 Series.