User`s guide
VigorTalk ATA24 Series User’s Guide
46
Send only one wild RSIP – Only one RSIP message (e.g.,
aaln/*@[172.16.3.5]) will be sent to call agent to indicate all
ports are initiated/restarted.
Range Wildcard RSIP Click Enable to send out RSIP message (e.g.,
aaln/*@[172.16.3.5]).
Click Disable to close such function.
HearBeat Click Enable to check if MGCP server can work normally or
not, otherwise click Disable.
HearBeat Period Type the interval for the system to check the MGCP server.
HearBeat Retry Type the times for the system to check the MGCP server.
z For H248 Configuration
H248 Call Agent Address The IP address of the Call Agent server in H248.
H248 Call Agent The port number for the Call Agent server in H248.
H248 MessageID Mode Choose one of the modes for MessageID (defined by H248).
Settings configured in Message ID field are used to be
identified by the server supported with H248.
H248 MessageID IP Mode If you choose WAN IP Address, the system will use WAN IP
address configured in Network for such protocol; if you choose
Manual IP Address, you have to type IP address manually in the
field of H248 MessageID Address below.
H248 MessageID Address Type WAN IP address used for the server supported with H248
when you choose Manual IP address as H248 MessageID
Address.
H248 MessageID Port The port number for MessageID.
H248 Local Port The UDP port number in H248 local terminal.